Yes, Mach3 (the software profram) will work with Windows 7, and windows 10 when coupled with the Mach3 USB interface. The spindle continues to spin but all jog capabilities are frozen, and cannot turn the spindle off (Emergency cutoff on the router table still works however).
If you intend to use the parallel port driver, stick with Windows 7 in 32-bit mode. Rnrmotion.dll is a dynamic link library which is very similar in function to an executable program, or app. This occurs at random times, sometimes 5 minutes into a job, sometimes 6 hours into a job. Will happen with router bit deep into work piece and will also happen when spindle is lifted up and jogging over the next g code line. There are no patterns when when it occurs, and leads me to believe it is completely random. What I do to remedy is exit out of MACH 3 and save fixture before leaving. #Mach3 cnc windows 10 codeĪfter rebooting MACH3 I manually enter in the line of g code it froze on and continue the job. The computer (dedicated solely to M3 and nothing else) itself running M3 is not frozen. I have had stepper driver issues before, but this doesnt seem anything like those types of issues. I really don't think it's an issue with the cnc router itself.Įdit: PC running windows xp 32 bit, celeron processor, 2gb memory, 500gb hard drive, dedicated only to M3, Is not connected to internet, updates off, power save / sleep mode off.
Running control board with 25pin serial connection.
0 kommentar(er)
